DISTISO6 Isolated Distribution Amplifier 6 Output

139,99 €
In stock – ships within 1–2 working days

Distribution Amplifier with 6 Galvanically Isolated outputs Designed by circuitvalley in Germany

SKU: DISTISO6
Category:

What is it?

Signal Distribution Amplifier for Clock and Signal Distribution, With Bandwidth 100Khz to 190Mhz with Gain of +4dBm

Input 

50 Ohm Input impedance ,

AC coupled  to Primary Stage,  Max 2V DC Offset

Max  +10dBm  for 100Khz to 100Mhz, 2Vpp + 2V DC Offset

Max +17 dBm Max 101 to 190Mhz

A standard 3.3V CMOS or TTL when driving into 50R will fall into compatible range.

If you have requirement of even Higher input voltage then external BNC attenuator can be used

Output

50 Ohm Galvanically Isolated

+13dBm  100Khz to 50Mhz into 50Ohm , ~6Vpp into 1Mohm

+12 dBm 50 to 100 Mhz into 50Ohm

+7 dBm 101 to 190Mhz into 50Ohm

Frequency Deviation between Channels

Base line Measured Ratio difference on same Channel max  7.956p

Channels Between same driver (e.g CH1 vs CH2) max Ratio difference of around  8.16p

Channels Between different driver (e.g CH1 vs CH3) max Ratio difference of around 10.2p , Max ~ 10 PPT

Phase Noise

Measured only with Spectrum analyzer, Device should perform same or better. Measurement are limited by noise floor of Generic SSA

-70dBc/Hz@1Hz

-90dBc/Hz@10Hz

-114dBc/Hz@100Hz

-125dBc/Hz@1Khz

Phase Deviation between Channels

TDS8000 70Ghz Bandwidth scope Was used with 50Ghz and 20Ghz sampling head, even on 1fs resolution no measurable phase difference

Power

Dual Power input

USB C PD 15 V or 12V

DC Banana Jack 6.5mm 2mm Pin Center Positive

 

You Can buy this device with a High Quality  USB C Power Supply, With High Quality USB C Cable for additional cost/

Output Amplitude

 

Specs & Docs

Chose Power Supply

Just Amplifier Device, With USB C Power Supply + USB C Cable

Hersteller / Manufacturer:
…

Verantwortliche Person in der EU / Responsible person in the EU: der Hersteller (siehe oben) / the manufacturer (see above)

Produkt / Product: DISTISO6 Isolated Distribution Amplifier 6 Output — Art.-Nr. / SKU: DISTISO6

WEEE-Reg.-Nr.: DE90905884

Sicherheitshinweise / Safety information:

  • Elektronische Baugruppe für technisch versierte Anwender – kein Spielzeug. Außerhalb der Reichweite von Kindern aufbewahren.
    Electronic assembly for technically skilled users – not a toy. Keep out of the reach of children.
  • Empfindlich gegen elektrostatische Entladung (ESD): nur an einem geerdeten Arbeitsplatz handhaben.
    Sensitive to electrostatic discharge (ESD): handle only at a grounded workstation.
  • Nur mit der angegebenen Versorgungsspannung und geeigneten Netzteilen betreiben; Ein- und Ausgänge nicht mit falscher Spannung beschalten.
    Operate only with the specified supply voltage and suitable power supplies; do not apply wrong voltages to inputs or outputs.
  • Nicht in feuchter oder nasser Umgebung verwenden und vor Überhitzung schützen.
    Do not use in damp or wet environments; protect from overheating.
  • Entsorgung: nicht in den Hausmüll – bei einer Sammelstelle für Elektroaltgeräte abgeben.
    Disposal: do not put in household waste – take to a collection point for waste electrical equipment.

There are no reviews yet.

Be the first to review “DISTISO6 Isolated Distribution Amplifier 6 Output”

Your email address will not be published. Required fields are marked *

Are you human? Please solve:Captcha